ALLEY BUMPS
ALLEY BUMPS
Need an Install? Done!
Reduces speed to 1-5 KM/H
Constructed from 100% recycled tires, our alley bumps are preformed to ensure a smooth, safe ride. The Alley Bump's flexible design conforms to the contour of virtually any road surface. The bumps can be easily removed for storage or relocation. Designed to withstand extreme temperature variations, the bumps are resistant to moisture, oil, and ultraviolet light. They will not warp, crack, chip, or rot. The molded highly reflective tape ensures that the alley bumps are visible even on a dark night. Cat's eye reflectors further enhance visibility to alert drivers well in advance. The bumps have a channeled bottom to facilitate drainage as well as to cover cabling or piping.The Alley Bump is available in 6' lengths, including end caps to protect the bump ends as well as vehicles. Our rubber alley bumps are covered by a 3 year warranty.
Dimensions
Alley Bump
(L) 6' x (W) 12" x (H) 3" - 76 lbs.
End Cap
(L) 9" X (W) 12" X (H) 3" - 8 lb
● Made of 100% recycled tires
● Long lasting and cost efficient
● Reduces speed to 1-5 km/h
● Will not crack, fade, warp, chip or rot
● High visibility at night
● Product can be installed in sections to create varying lengths
● Can be installed on any road surface
● Resists sun, moisture, oil & extreme temps
● Temporary or permanent installation - Relocatable when resurfacing / maintaining road surfaces
● Products can be stored & re-used.
● Removable for snow plows.
● Channeled bottom for cabling and piping
● Maintenance free
● 3 year warranty
Asphalt speed bumps are susceptible to damage from snow plows and vehicles that bottom out from speeding over the bumps. They carry a 1 year warranty vs our 3 year warranty. Asphalt speed bumps must be painted every 1 to 2 years and they cannot be removed annually if required. They are also permanant in height in comparison to rubber bumps which can be swapped out for a different height and with new vehicles on the road being lower to the ground, our low rider bumps are great for low clearance vehicles.
APPLICATIONS
Used for the following situations:
● Improving pedestrian safety and vehicle traffic flow.
● To further support and reinforce stop signs in parking lots.
● When high risk of accidents on residential streets and parking lots need to be reduced.
● When permanent or temporary lowering of speeds of motor vehicles is required.
● When only temporary installation is allowed or required.
● Installation on surfaces where only flexible rubber speed bumps can fully conform to the curvature of the road.